Kenwood CD RECEIVER KDC-4060RA - Manual (Page 20)

Other features
(See page 8)
— 20 —
English
Audio Control Setting
Adjust various parameters of sound quality.
Press the AUD button to enter the control mode.
Each time the AUD button is pressed, the adjustment mode
display changes as follows:
7 Bass 7 Treble 7 Balance 7 Fader 7 Volume
If you do not move to step 2 in 5 seconds, the unit will switch
back to the volume adjustment mode (i.e., the normal mode).
Source tone memory
Each source (CD, FM, and AM) has its own memory in which to
store the bass and treble tone settings.
The settings made for a particular source are then recalled
automatically whenever you use that source (e.g., FM mode uses
the tone settings made for FM, AM for AM, etc.).
Press the d/u buttons to adjust the mode shown in the
display.
Use the following table as a guide for adjusting the settings in
each mode.
2
NOTE
1
Bass
(“BAS”)
Treble
(“TRE”)
Balance
(“BAL”)
Fader
(“FAD”)
Bass decreased.
Treble decreased.
Left channel
emphasized.
Rear channel
increased.
Bass increased.
Treble increased.
Front channel
increased.
Right channel
emphasized.
Adjustment
mode
(Display) d button u button
Operation of Audio control button
Clock Display
Display the time.
Switching to Time Display:
Press the CLK button repeatedly until the clock is displayed.
Adjusting Time
When the RDS station tuned into is transmitting a time signal,
have the unit’s built-in time adjust automatically to the
correct local time.
Adjusting the Time:
Tune into an RDS station for 3 or 4 minutes.
The time adjusts automatically to the correct local time.
• The displayed time cannot be set manually, but only through
RDS station time signals.
• The time is not adjusted when the RDS station you are tuned to
is not transmitting a time signal. Choose another RDS station in
such a case.
NOTE