Kenwood CD-RECEIVER KDC-PS9080R - Manual (Page 14)

“HPF Rear” : Adjust the frequency of the High-pass filter for rear
output.
Setting values: Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz /
150Hz / 180Hz / 220Hz
You can separately set the high-pass filter for front and rear
output, including preouts. The high-pass filter works except
during non-fading preout when switching to non-fading (KDC-
8080R only). The factory default settings for front output and rear
output are "through" .
NOTE
“HPF Front” : Adjust the frequency of the High-pass filter for
front output.
Setting values: Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz /
150Hz / 180Hz / 220Hz
You can separately set the high-pass filter for front and rear
output, including preouts. The high-pass filter works except
during non-fading preout when switching to non-fading (KDC-
8080R only). The factory default settings for front output and rear
output are "through" .
NOTE
“NFpre Level” : Adjust the Non-fading output level.
Setting values: - 15 – + 15
• This mode is available only when the non-fading output function
is set to on. (KDC-8080R only)
• Not available during the Dual zone system is on.
NOTE
“Fader” : Adjust the fader level.
Setting values: Front 15 – Rear 15
“Balance” : Adjust the balance level.
Setting values: Left 15 – Right 15
“Tre” : Adjust the treble level.
Setting values: - 8 – + 8
“Tre Frq” : Adjust the centre frequency of the treble.
Setting values: 10.0 / 12.5 / 15.0 / 17.5 kHz
This mode is available only when the Sound coordinate system is
on. (page 36).
NOTE
“Bass EXT” : Switch the Bass Extend mode on/off.
Setting values: ON / OFF
(When the bass extend mode is set to on, low
frequency response is extended by 20%.)
This mode is available only when the Sound coordinate system is
on. (page 36)
NOTE
General features
— 14 —
English