Konica Minolta Fax Kit (FX-3) - Manual (Page 56)

4.1 Transmission Methods 4
Fax Kit (FX-3) 4-5
F
a
x T
ran
sm
is
si
on
/R
ec
ep
ti
o
n
Me
th
od
s
Ch
apte
r 4
To send a fax manually
1 Load the document into the Automatic Document Feeder.
2 If necessary, change the “Resolution” setting (p. 3-11).
3 Pick up the telephone receiver.
❍ Check that the dial tone can be
heard.
4 Specify the fax number of the recipient.
❍ Use the telephone to dial the fax number.
❍ The fax number of the recipient can also specified using the keys in the
control panel of this machine (p. 3-2).
5 After finishing talking on the phone, the recipient should press the necessary
key to start receiving the fax.
Once the recipient’s fax machine is ready, a beep is sounded.
6 Press the [Start] key to begin
scanning and sending the fax.
7 Replace the telephone receiver.
❍ To stop the transmission, press the [Stop] key, and then press the [Yes] key
in the next screen that appears.
✎
Tip
If the [Speaker] key is pressed instead of picking up the telephone receiver, the
speaker can be used for manual transmission in the same way as described
above.