Konica Minolta Fax Kit (FX-3) - Manual (Page 66)

4.1 Transmission Methods 4
Fax Kit (FX-3) 4-15
F
a
x T
ran
sm
is
si
on
/R
ec
ep
ti
o
n
Me
th
od
s
Ch
apte
r 4
5 Specify the relay station, and then
press the [Yes] key.
❍ Refer to “Dialing” on page 3-2.
A screen appears, allowing you to
specify the relay box ID.
6 Using the 10-Key Pad, enter the
relay box ID.
❍ Enter the relay box ID (20
digits or less) programmed at
the relay station.
❍ The only characters that can be used in the mailbox ID are 0 through 9, ,
and #.
❍ If you wish to correct the ID, press the [No] key, and then enter the new
number.
7 Press the [Yes] key.
A screen appears, allowing you to specify the password.
8 Using the 10-Key Pad, enter the
password.
❍ Enter the password (20 digits
or less) if a password has been
set at the relay station.
❍ The only characters that can be used in the password are 0 through 9, ,
and #.
❍ If you wish to correct the password, press the [No] key, and then enter the
new number.
9 Press the [Start] key to begin scanning and sending the fax.