Konica Minolta Bizhub C20P - Manual (Page 171)

Replacing Consumables 157
11
Use DATE on the SYS DEFAULT MENU/CLOCK menu to set the date,
and use TIME on the SYS DEFAULT MENU/CLOCK menu to set the
time.
Replacing the Fuser Unit
When the time to replace the fuser unit is reached, the message FUSER
UNIT/END OF LIFE appears. Printing can continue even after this mes-
sage appears; however, since the print quality is reduced, the fuser unit
should be replaced immediately
1
Turn off the printer.
Note
There are extremely hot parts within the machine. Before replacing the
fuser unit, wait about 20 minutes after turning off the machine, and then
check that the fusing section has reached room temperature, otherwise,
you may get burnt.
2
Pull the lever, and then open the
right side cover.
"
Before opening the right side
cover, fold up Tray 1.