Kenwood KDC-507 EN - Manual (Page 9)

switch as shown below.
4 Adjust the Audio item
Press the [
4] or [¢] button.
Adjustment Item Display Range
Bass level "Bass"/ "BAS" –8 — +8
Middle level "Middle"/ "MID" –8 — +8
Treble level "Treble"/ "TRE" –8 — +8
Balance "Balance"/ "BAL" Left 15 — Right 15
Fader "Fader"/ "FAD" Rear 15 — Front 15
Non-Fading level* "NF Level" –15 — +15
Front/Rear High "HPF" Through/100/125/170 Hz
Pass Filter*
Non-Fading
"LPF NF" 50/80/120/Through Hz
Low Pass Filter*
Volume offset
"V-Offset"/ "V-OFF" –8 — ±0
Loudness "LOUD" ON/OFF
• Volume offset: Each source's volume can be set as a difference
from the basic volume.
• Loudness: Compensating for low and high tones during low
volume.
• * Function of the KDC- M6024G/M6024/V6524/6024
5 Exit Audio Control mode
Press the [AUD] button.
1 Select the source for adjustment
Press the [SRC] button.
2 Enter Audio Control mode
Press the [AUD] button for at least 1 second.
3 Select the Audio item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed the items that can be adjusted
Audio Control
You can recall the best sound setting preset for different types of
music.
1 Select the source to set
Press the [SRC] button.
2 Select the Sound type
Press the [System Q] button.
Each time the button is pressed the sound setting switches.
Sound setting Display
Flat "Flat"/ "FLAT"
User memory "User"/ "USER"
Rock "Rock"/ "ROCK"
Pops "Pops"/ "POPS"
Easy "Easy"/ "EASY"
Top 40 "Top40"/ "TOP40"
Jazz "Jazz"/ "JAZZ"
• User memory: The values set on the <Audio control> (page 9).
• Each setting value is changed with the <Speaker setting> (page
10).
First, select the speaker type with the Speaker setting.
System Q
— 9 —
KDC-M6024G_U.S r4 02.11.8 9:22 AM Page 9