Selecting player a or b – Kenwood CD-4900M User Manual
Page 18
18
Preparation
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Notes
Notes
MODE
SET
L
A
L
A
D
A
T
R
A
E
3
D
D
D
S
I
C
C
E
R
D
A
N
I
3
G
0
D
1
0
:
:
D
C
T
A
X
E
3
T
Disc replacement
Discs can be replaced with the same procedure as “Loading discs
in the carousel”.
In stopped condition, all discs can be exchanged.
However, when the disc door is opened while “DISC DETEC-
TION” is being displayed, it may not be possible to remove the
disc which had been played. Accordingly, wait for the “DISC
DETECTION” indication to go out before opening the disc door.
When the disc information has been read in at the time of regis-
tration of disc information like title, music type, etc., the disc
information can be recalled even when the disc insertion place
is changed.
⁄
In regard to ALL DATA READ mode (Player A only)
The disc information for all discs will be read. It is convenient to
execute this mode before playback after discs have been exchanged.
Close the disc door before operation.
1 Press the MODE button.
2 Select “ALL DATA READ”.
3 Set the input.
Each press switches the modes as follows:
1 MUSIC TYPE
2 DISC SEARCH
3 TITLE INPUT
4 ALL DATA READ
5 ALL INFORMATION
6 DTS DISC SKIP
Search in progress or
reading information
The display flashes.
When the disc is CD-TEXT
÷ Repeat the above procedure so that the complete disc information is
read into the CD player.
÷ In the case of a non-CD-TEXT disc, the “D001:NO CD TEXT” display
will appear for approx. 3 seconds.
÷ This operation is not available during the continuous play mode.
1. Please remove all CDs from the carousel before moving the unit.
2. If blinking “PLEASE WAIT“ is displayed when the disc door is opened, do not attempt to change the disc.
To quit ALL DATA READ mode
Press the
7 button.
OPERATION
B
A
DISPLAY-A
÷ Each press of the button switches Players A and B alternately and lights
the indicators accordingly.
÷ After selecting the Player, operate the player.
÷ The OPERATION A-B button is set to A during continuous play mode.
It is not possible to switch the Player during it.
÷ If a registered DTS disc is selected when the Player B is selected,
blinking “DTS DISC!“ is displayed and the DTS disc selection is
cancelled.
•
To display the title on a LCD remote control unit (provided
with a KENWOOD Receiver or optional), perform the all data
read operation first, and operate the LCD remote control unit
with the door left closed. For the operation of the LCD
remote control unit, refer to the instruction manual provided
with your receiver or LCD remote control unit.
Selecting Player A or B
The audio played on Player A is output from OUTPUT-A and that
played on Player B is output from OUTPUT-B. This makes it pos-
sible to enjoy different music in different rooms.
Main unit
DISC SKIP
DOWN
UP