KITCHENAID KERA205 - Manual (Page 13)

13
Timer
The Timer counts down the set time. On models with electronic
oven control Style 1, the timer can be set in minutes and seconds
or hours and minutes.
NOTE: The Timer does not start or stop the oven.
1. Press TIMER SET/START.
On models with electronic oven control Style 1, press again
to switch from MIN/SEC and HR/MIN.
If no action is taken after 4 minutes, the display will return to
the time of day mode.
2. Press the number pads to set length of time.
3. Press TIMER SET/START to start the timer.
If not pressed within 4 minutes, the display will return to the
time of day mode and the programmed function will be
canceled.
When the set time ends, timer completion tones will sound,
then reminder tones will sound every minute.
4. Press TIMER OFF anytime to cancel the Timer and/or stop
reminder tones.
Remember, if OFF is pressed, the oven will turn off.
5. The time can be reset during the countdown by repeating the
above steps.
OPTIONS - STYLE 1
Options Selection Pad
The OPTIONS selection pad allows you to access special
functions within the Electronic Oven Control that allow you to
customize the product to your needs. These special functions
allow you to change the oven temperature between Fahrenheit
and Celsius, turn the audible signals and prompts on and off, and
adjust the oven calibration. The Sabbath Mode is also set using
the OPTIONS selection pad.
To Use: Press OPTIONS. The oven display will scroll through the
various options, starting at 1 and ending in 7. You can also press
the OPTIONS selection pad and number pad to quickly access
the desired hidden function.
Fahrenheit and Celsius
Press options, then 1 on the keypad for Celsius. Repeat to
convert back to Fahrenheit.
Tones
Tones are audible signals, indicating the following:
One beep
■ Function has been entered
Three beeps
■ Invalid pad press
Timer Completion Tones
Four chimes occur when the timer reaches zero. This can occur
when using the timer for functions other than cooking.
Cooking Time Completion Tones
Three beeps indicate the end of a cooking cycle.
To turn On/Off: Press OPTIONS, and then 4 to turn OFF. Press
OPTIONS, and then 4 to turn ON.
Preheat Completion Tone
One chime indicates a preheat cycle has been completed.
All Tones
All tones are preset ON, but can be turned OFF. To turn tones ON,
press the options key, then press keypad 2. To turn tones OFF,
press the options key again, and then press keypad 2.
Tone Volume
The volume is preset at high, but can be changed to low.
To Change: Press OPTIONS, and then 3 to lower the volume.
Press OPTIONS, and then 3 to raise the volume of the tones.
Oven Temperature Calibration
IMPORTANT: Do not use a thermometer to measure oven
temperature because opening the oven door during cycling may
give incorrect readings.
The oven provides accurate temperatures; however, it may cook
faster or slower than your previous oven, so the temperature
calibration can be adjusted. It can be changed in Fahrenheit or
Celsius.
A minus sign means the oven will be cooler by the displayed
amount. The absence of a sign means the oven will be warmer by
the displayed amount. Use the following chart as a guide.
To Adjust Oven Temperature Calibration:
1. Press OPTIONS, and then 6 to set the calibration.
2. Press 3 to increase the temperature, or press 6 to decrease
the temperature.
3. Press START to end calibration.
OPTIONS SPECIAL FUNCTION
1 Fahrenheit and Celsius conversion
2 Tones On and Off
3 Tones High and Low
4 Cooking Time Completion Tones On and Off
6 Oven Temperature Calibration
7 Sabbath Mode
ADJUSTMENT °F (AUTOMATIC
°C CHANGE) COOKS FOOD
10°F (5°C) ...a little more
20°F (10°C) ...moderately more
35°F (15°C) ...much more
-10°F (-5°C) ...a little less
-20°F (-10°C) ...moderately less
-35°F (-15°C) ...much less