Kenwood KDV-MP3346 - Manual (Page 4)

4 ENGLISH
4
Finish the procedure.
ˆ Setting the clock
1
Turn on the power.
2
Enter Function Control settings.
3
Turn the control knob to make a
selection, then press to confirm.
1 : 00
4
Adjust the hour.
Preparation
[Hold]
The display demonstration is always turned on
unless you cancel it.
When you turn on the power (or after you reset
the unit), the display shows:
“CANCEL”
= “DEMO” = “PRESS” =
“VOL KNOB”
• If no operation is done for about 15 seconds,
“DEMO START” appears and the display
demonstration starts.
To cancel the display demonstration:
1 Press the control knob.
“NO/<YES>” is shown on the display.
2 Press the control knob again to select
“YES”.
“DEMO OFF” appears on the display.
• If “NO” is selected, “DEMO START”
appears and the display demonstration
starts.
You can also cancel the display demonstration
from the Function Control settings, see the
following:
ˆ Canceling the display
demonstration
1
Turn on the power.
2
Enter Function Control settings.
3
Turn the control knob to make a
selection, then press to confirm.
EN02-11_KDV-MP3346M[U]f.indd 4 EN02-11_KDV-MP3346M[U]f.indd 4 11/19/09 4:44:16 PM 11/19/09 4:44:16 PM