Kenwood C-V301 - Manual (Page 10)

10
C-V351/C-V301 (EN)
OPEN/CLOSE
Note Note
Opening/closing the door
When opening or closing the door, be careful not to catch
your finger in the door. Otherwise there is a risk of injury.
Changing the input selection display (AUTO key)
1 Select “TAPE 1” with the INPUT SELECTOR .
2 Press and hold the AUTO key for more than 2 seconds, until
“MD” is displayed.
*1: To change the TAPE 1 display to MD display
*2: To change the LD display to the DVD display
Each press switches the indication.
Each press switches the indication.
To make the system control operation, the input selection display
should be switched according to the actually connected compo-
nents.
About the system control connections
7
Switching the display mode (DISPLAY key)
Use the following procedure to change the display mode.
Press the DISPLAY key (RC and GRC only).
Select "Display" from "Main Menu 2" when using the GRC.
Each press switches the indication.
÷ The time display is displayed for only 5 seconds, after which the INPUT
SELECTOR display appears automatically.
÷ The display of 2 is not shown during SOURCE DIRECT and 6ch INPUT
operations.
÷ With the C-V301, the display does not change while the INPUT
SELECTOR is set for the LD input.
1 TAPE1 2 MD
1 LD 2 DVD
1 INPUT SELECTOR
display
2 DOLBY/DSP/
STEREO
display
3 Time
display
1 Select “LD” with the INPUT SELECTOR .
2 Press and hold the AUTO key for more than 2 seconds, until
“DVD” is displayed.
Controls and indicators