Kenwood C-V301 - Manual (Page 12)

12
C-V351/C-V301 (EN)
3
1
2
ON/STANDBY
MUTE
VOLUME
ENTER
Model Type Setup
Model 6
Model 5
Model 4
Model 3
Model 2
Model 1
Model Type Setup
Model 6
Model 5
Model 4
Model 3
Model 2
Model 1
1
3
2
4
Set Up
ENTER
Reset
ENTER ENTER
ENTER
Setup of the Graphical Remote Control (GRC) unit
Setting up the GRC according to your AV CONTROL CENTER
(Model Type Setup)
Perform the following procedure after inserting batteries for
the first time and every time after changing them.
Preparation
÷ Press the (ON/STANDBY) key
of the main unit to the ON mode.
Model Type Setup (GRC setup procedure)
Loading batteries
1 Remove the cover. 2 Insert batteries. 3 Close the cover.
The “Model Type Setup” screen ap-
pears.
Check the display.
Select "Model 2."
Move the cursor.
It can be moved in 8 directions depend-
ing on how you press the joystick key.
Enter the selection.
Press the ENTER key.
1 Select Set Up.
2 Press the ENTER key.
4 Press the ENTER key.
3 Select Reset.
5 Perform the setup procedure from step ”2 Check the display”.
To reset GRC setting
GRC
“Model Type Setup” icon
Main operation menu
C-V301 ............................................... Model 2
C-V351 ............................................... Model 2
AV CONTROL CENTER
Model
For C-V351
The icon on which the cursor is moved blinks in reverse
video.
Caution in battery replacement
÷ Insert four AA-size (R6/AA) batteries
as indicated by the polarity marking.
÷ To maintain the memory of the settings you
made before, complete the battery replace-
ment operation within 30 seconds.
÷ The procedure on the left should also be per-
formed when resetting the GRC (as a measure
against its malfunction). However, in this case,
wait for about five minutes after removing the
batteries and before re-inserting them.
÷ The above operation clears all of the previously made settings and
resets the unit to the initial condition.