Kenwood C-V301 - Manual (Page 22)

22
C-V351/C-V301 (EN)
AV CONTROL CERTER KC-2
1
2
INPUT
4
VOLUME CONTROL
DOWN UP
ON/STANDBY
3
ENTER
ENTER
VOLUME
C D
CD
ENTER
ENTER
ON/STANDBY
Playing music
The following procedure allows to play a CD, MD, DVD or
cassette tape.
Preparations
÷ Connect components as described in “System connection”.
5
÷ Complete “Setup of the Graphical Remote Control (GRC) unit”.
!
: Keys or controls to be used in this operation
Press the ON/STANDBY key to ON.
Select the input source.
Play the selected source.
Operation on each
source compo-
nent
Adjust the volume.
To
decrease
volume To
increase
volume
To decrease volume
To increase volume
1 VCR
2 AUX
3 TAPE 1 / MD *1
4 TUNER (frequency display)
5 CD
6 LD / DVD *2
7 6ch INPUT
With the main unit operation, the input sources are switched as shown below.
*1: To change the TAPE 1 display to MD display
*2: To change the LD display to the DVD display
To enable system-control operation, the displayed information should
be set according to the actually connected components.
0
÷ Note for using the 6ch INPUT ∞
÷ Step 3 can be omitted if the easy operation feature is available. ¡
One-touch operation
Pressing the play key of the CD player, DVD player or cassette deck
starts up the system automatically and starts playback. When this
operation is used, steps
1 and 2 can be omitted. ¡
Volume level is displayed.
÷ The time taken till the volume level is displayed is variable depending
on the current operating condition.
÷ Rotating the VOLUME CONTROL at a higher speed increases the
amount of volume change (AI VOLUME function).
÷ The sound of input source cannot be listened to while TAPE 2
(MONITOR) is ON.
dB V O L U M E - 5 )
÷ Load the CD player, MD recorder, DVD player or cassette deck with
the software to be played.
\Read the instruction manuals of the associated components. POWER
INPUT
6
%
fi
VOLUME
To decrease volume
To increase volume
Main unit GRC RC
Main unit GRC RC
Main unit GRC RC
Main unit GRC RC
Main
Menu