Kenwood RC-2000 - Manual (Page 7)

3
FRONT PANEL INSTALLATION
1 Assemble the mounting brackets using the 2 supplied
hexagon SEMS screws and the 2 flat washers.
• Do not completely tighten the screws in this step.
2 Peel off the paper backing from the base of the
bracket.
3 Position the bracket in the vehicle, then install it
securely using the 3 supplied self-tapping screws and
the 3 flat washers.
4 Align the grooves on the front panel over the bracket
tabs.
5 Slide the front panel down until it locks in place.
• The tab on the front panel must be completely
locked by the bracket otherwise vehicle vibration
may cause the front panel to become dislodged.
6 Position the front panel at your desired angle, then
completely tighten the 2 SEMS screws on the
bracket.
SEMS screw
Self-tapping screw
Flat washer
Bracket tab
Locking tab
SEMS screw
4 mm x 10 mm
4 mm x 14 mm