Kyocera K112 - Manual (Page 7)

8VHU *XLGH IRU WKH .\RFHUD . 3KRQH 
1 G ETTING S TARTED
This document describes the Kyocera K112 phone,
with CDMA digital and analog service at 800 MHz.
Your phone comes with an integrated, rechargeable
Lithium Ion (LiIon) battery, which is not fully
charged.
Inserting your RUIM card
The RUIM card is supplied by your service provider
when you register as a user. It contains all the
important data pertaining to your phone.
Important: Make sure that the phone is turned off
and is disconnected from the charger before you
insert or remove the RUIM card
1. Hold the phone face down.
2. Remove the RUIM card cover located at the
lower end of the phone by sliding it down.
3. Place the RUIM card into its
compartment with the metal
contacts facing down and the
cut corner to the left.
4. Slide the RUIM card cover
back onto the phone until it
latches.
Do not force.
Charging the battery
Fully charge the new battery for approximately 12
hours before using the phone for the first time.
To charge the battery,
connect the power adapter
to the jack located at the
bottom left of the phone,
then connect the adapter’s plug to a wall outlet.
The battery icon at the top-right corner of the
screen tells you whether the phone is:
• Charging (animated icon)
• Partially charged
.
• Fully charged .
• Low battery . Icon blinks and the phone
beeps. The phone screen displays a “Low
Battery” message. When the battery is
completely drained the phone powers off.
82--K5456-1EN.book Page 1 Thursday, November 6, 2003 5:16 PM