Kodak A-61003 - Manual (Page 8)

A-61003 September 1993 EB-6
OPERATIONS CHECKLIST
Microimager 70 Setup:
√
Turn on main power switch, if necessary.
√
Turn on side panel switch.
√
Load film into cassette(s).
√
Load film cassette(s) into machine.
√
Select the lens holder position.
√
Select the mask.
√
Adjust the feed/separator rollers.
√
Adjust the feed shelf.
√
Adjust the feeder side guides.
√
Adjust the exit hopper side guides.
√
Adjust the exit hopper end stop.
√
Install the proper exit hopper deflector.
√
Perform an exposure step test, if necessary.
√
Prepare documents to feed into transport.
Running a Job:
√
Select an application mode.
√
Input any temporary/override operating values.
√
Enter or verify the starting Image Address.
√
Enter or verify the starting document image level.
√
Press the Run key.
√
Feed documents.
√
Press the Stop key.
√
Remove documents from the exit hopper.
√
Unload film cassette(s) from the machine.
√
Unload film from the cassette(s), if necessary.
√
Turn off side panel switch.
√
Turn off main power switch, if necessary.