Editing, Preparation, Light the “edit” indicator – Kenwood D-R350 User Manual
Page 20: Enter the recording time of the tape, Select the disc
D-R350 (En)
20
The following procedure allows to record a CD within the specified tape length so that no music is interrupted in the middle
at the ends of sides A and B.
Editing
1
Light the “EDIT” indicator.
Preparation
÷ Load a disc in the CD player.
÷ Check that the unit is in the normal play
TRACK mode.
#
÷ Set the INPUT SELECTOR to ”CD“ on the
connected device such as AV CONTROL
CENTER or receiver.
2
Set the entry.
Time
ENTER
1
Select the time.
When using the TIME key:
+10
5
4
3
2
1
0
9
8
7
6
1 2 3
4 5 6
7 8 9
0 +10
ENTER
When using the numeric keys:
GRC operation
RC operation
3
GRC operation
RC operation
Mode
Edit
ENTER
ENTER
: Keys and control used in the operations described on this page.
EDIT MODE
D
E
T
I
D
S
I
?
C
Blinks.
÷ Do this operation in the stop mode.
RC operation
Press the numeric keys as shown below...
30-minute tape :
000)
46-minute tape :
00006
GRC operation
Press the ENTER key after selecting each numeric
icon.
30-minute tape :
0ENTER, 0ENTER,
0ENTER, )ENTER
D
E
T
I
D
S
I
3
C
C
4
-
6
÷ Recording within 99 minutes can be specified in minutes (2 digits).
÷ If you commit a mistake in time entry, press the P.MODE key and
restart the procedure from the beginning.
÷ By pressing the TIME key the set time-length intervals will change in
this order:
÷ The interval length can be adjusted with the skip keys 4 and ¢ in
units of one minute (to a maximum of 99 minutes).
"
46
=54=60=74=90=
??
"
=
ENTER
E d i t
GRC operation
: Complete the procedure in “Basic Operations
for the Graphical Remote Control Unit (GRC)”
90
Enter the recording time of the tape.
Go to step
3
within 8 seconds.
GRC operation
RC operation
Disc Skip
ENTER
E d i t
ENTER
Select the disc.
2
Go to step
2
within 8 seconds.
If more than 8 seconds have elapsed,
press the key again.
REPEAT
DISC SKIP
EDIT MODE
➡
EDIT MODE
TIME