Location requirements, Installation clearances – Kenmore 110.4708 User Manual

Page 6

Advertising
background image

6

Location Requirements

Selecting the proper location for your washer improves
performance and minimizes noise and possible washer “walk.”

Your washer can be installed under a custom counter, or in a
basement, laundry room, closet, or recessed area. See “Drain
System.”

Companion appliance location requirements should also be
considered. Proper installation is your responsibility.

You will need

■

A water heater set to deliver 120°F (49°C) water to the
washer.

■

A grounded electrical outlet located within 6 ft (1.8 m) of
where the power cord is attached to the back of the washer.
See “Electrical Requirements.”

■

Hot and cold water faucets located within 4 ft (1.2 m) of the
hot and cold water fill valves, and water pressure of
20-100 psi (137.9-689.6 kPa).

■

A level floor with a maximum slope of 1" (2.5 cm) under
entire washer. Installing the washer on soft floor surfaces,
such as carpets or surfaces with foam backing, is not
recommended.

■

A sturdy and solid floor to support the washer with a total
weight (water and load) of 400 lbs (180 kg).

Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures.

Installation clearances

■

The location must be large enough to allow the washer door
to be fully opened.

■

Additional spacing should be considered for ease of
installation and servicing.

■

Additional clearances might be required for wall, door, and
floor moldings.

■

Additional spacing of 1" (2.5 cm) on all sides of the washer is
recommended to reduce noise transfer.

■

Companion appliance spacing should also be considered.

Washer Dimensions

Recommended installation spacing for custom
undercounter installation

The dimensions shown are for the recommended spacing.

Custom undercounter installation - Washer only

Recommended installation spacing for recessed or
closet installation, with or without a pedestal

The dimensions shown are for the recommended spacing.

Recessed area or closet installation

*Min. top and bottom air openings for closet door.

Recessed or closet installation - Washer on pedestal

27"

(68.6 cm)

50

¹⁄₂

"

(128.3 cm)

38"

(96.5 cm)

31

¹⁄₂

"

(80.0 cm)

A. Side view - closet or confined area
B. Closet door with vents

A. Recessed area
B. Side view - closet or confined area

1"

(2.5 cm)

1"

(2.5 cm)

39" min.

(99.0 cm)

27"

(68.6 cm)

34"
(86.4 cm)

A

B

3"

(7.6 cm)

3"

(7.6 cm)

48 in.

2

*

(310 cm

2

)

24 in.

2

*

(155 cm

2

)

1"

(2.5 cm)

4"

(10.2 cm)

31

¹⁄₂

"

(80 cm)

1"

(2.5 cm)

31

¹⁄₂

"

(80 cm)

1"

(2.5 cm)

1"

(2.5 cm)

27"

(68.6 cm)

4"

(10.2 cm)

18" min.

(45.7 cm)

A

B

Advertising
This manual is related to the following products: