Kathrein UFS 650sw - Manual (Page 21)

21
FIRST INSTALLATION: single-cable system (manual)
If one or more receivers are already
present on the system and an
additional receiver is to be connected,
you must assign the new receiver a
transmission frequency that is not
already in use (otherwise the receivers
will interfere with each other).
Depending on the system to which they
are connected, a maximum of four or
eight receivers may be connected to
a single-cable system (a twin receiver
counts as two receivers)
No frequency can be used by more than one receiver.
The receivers would interfere with each other.
You can fi nd the necessary information (transmission frequencies) in the documentation
supplied with your system.
Secure channel with PIN
If your single-cable system allows the transmission frequency to be protected by inputting a PIN, this is the
menu where that can be done. No other receiver can then use that transmission frequency unless the PIN
is input.
Use the

buttons to select the setting “Yes”. A line with the text “Password PIN” is then displayed.
Press the

buttons to select this line. You can now use the number buttons to enter a PIN (0-255).
Connected equipment
Use the

buttons to select the type of system to which they are connected or the single-cable
system components fi tted (refer to the manuals, instructions and notes for the system and the system
components). Available options:
- user-defi ned
-
KATHREIN UAS 481 (single-cable feed system, max. four receivers)
- KATHREIN EXR 551 (single-cable switching matrix, max. four receivers)
- KATHREIN EXR 552 (single-cable switching matrix, max. four receivers)
- KATHREIN EXU 908 (single-cable matrix, max. eight receivers)
- EXR 4 subscriber (for future Kathrein single-cable (switching) matrices, max. four receivers)
- EXR 8 subscriber (for future Kathrein single-cable (switching) matrices, max. eight receivers)
Selection “user-defi ned”
Transmission channel
Use the

buttons to select a free available transmission channel.
Transmission frequency
Use the number buttons to input the four-digit transmission frequency.