KORG TONEWORKS AX3A - Manual (Page 8)

8
In Program mode you can instantly switch between sounds by pressing
the Program Up/Down switches to change programs.
To enter Program mode, set the function selector to [PROGRAM]. (The
LEDs in the upper part of the Program Up/Down switches will light.)
Selecting a program
1. Make sure that the function selector is set to [PROGRAM].
In Program mode, the LEDs of both the Program Up and Program
Down switches will be lit.
When you turn on the power, you’ll be in Program mode regardless
of the position of the function selector.
2. Turn the value knob to adjust the master volume.
If you've connected the AX3A to a guitar amp, set the master volume
to 50.
3. Press the Program Up or Program Down switch to select a program.
The program/value display shows the number of the program you
selected.
Creating your sound (Edit mode)
Signal flow
MIC&BODY PRE FX TONE
NOTCH VOLUME PEDAL MOD DELAY/REVERB
NR
VOLUME PEDAL is available only if a pedal is connected to the PEDAL
jack.
Edit mode is when the function selector is in one of the [PRE FX]–[DE-
LAY/REV PARAM] positions.
You can change the effect type for each category ([PRE FX], [DRIVE/
AMP], [LEVEL/NR/NOTCH], [MOD], [DELAY/REV]), and edit the param-
eters to create your sound.
Selecting effects and adjusting the main
parameters
[PRE FX], [MIC&BODY],[MOD], [DELAY/REV]
To select the effect you want to use in each of the categories [PRE FX],
[MIC&BODY], [MOD], and [DELAY/REV], set the function selector to the
appropriate position and use the [
▲
][
▼
] buttons.
The program/value display will indicate a value of F0–F9, and the LED
at the top of the Program Down switch will light to indicate that the pro-
gram/value display is showing the effect type
. If the function select knob
is set to [TONE], the P1-P4 values are displayed.
The effect list printed on the panel tells you the effect type that is se-
lected.
You can turn the value knob to adjust the “main” parameter for the se-
lected effect. At this time the program/value display will indicate the value
of the parameter, and the LED at the top of the Program Up switch will
light to indicate that the program/value display is showing the parameter
value.
To switch [TONE] on/off, press both of the [ ▲ ][ ▼ ] switches simultaneously.
The parameter type or value is shown if this is switched on, and an “ ”
indication if this is off.
■ Quick guide
When you select an effect, the AX3A automatically sets the parameters
of that effect to their most effective values. In other words, you can cre-
ate great sounds just by choosing an effect for each of the categories
PRE FX, MIC&BODY, MOD, and DELAY/REV, without having to make
detailed parameter settings.