Kenwood KRF-V7060D - Manual (Page 30)

30 EN
Ambience effects
DVD 6-channel playback
Using a DVD player or the like equipped with six (5.1) output channels and
the receiver, you can enjoy surround sound playback.
When you try to play a disc other than Dolby Digital such as DTS CD, no
sound is produced or, noise may be heard. To avoid this situation, make
sure that you connect the component to the receiver’s DVD/6CH INPUT
jacks through a surround processor which can decode the surround
signal you want to listen to.
Connecting a DVD player which can decode the surround signal itself is
also acceptable.
INPUT MODE
DVD/6CH
INPUT MODE
VOLUME
DVD/6CH
VOLUME /
Preparations
• Connect your DVD player to the DVD/6CH jacks of the receiver.
• Turn on all other components that will be used.
• Complete “Preparing for surround sound”.
*
1
Press “DVD/6CH” as the input source.
• If speaker system B is on when “DVD/6CH” is selected as the input
source, it switches off and speaker system A turns on automati-
cally.
2
Select "6CH INPUT" by pressing the INPUT MODE key.
3
Start playback of the DVD software.
4
Adjust the volume.
• It is not possible to adjust the volume level or sound quality (SET
UP, SOUND) of the channels separately when the receiver is in the
DVD/6CH mode. Adjust the volume with the controls of the DVD
player.
For the powered subwoofer, you can adjust the volume of the
subwoofer using the subwoofer’s own volume control.
Convenient functions
MULTI CONTROL DIMMER STEREO
SOUND LISTEN MODE
SOUND
LISTEN MODE %/ fi
STEREO
Joystick
(MULTI CONTROL 5 / ∞,
DOWN 2 / UP3)
DIMMER
Adjusting the sound
You can make further adjustments to the sound while listening to
playback in the surround mode.
1 Press the SOUND key and then use to the M M M M M/? ? ? ? ? keys or Joystick
( 2/3) until the desired item appears in the display.
Each time you press the M M M M M/? ? ? ? ? keys or Joystick ( 2/3), the menu
changes as follows:
Note that some items are not displayed in certain modes.
1 CNTR (Center speaker level adjustment)*
2 SR (Right surround speaker level adjustment)*
3 SB (Surround back speaker level adjustment)*
4 SL (Left surround speaker level adjustment)*
5 SUBW (Subwoofer level adjustment)*
6 INPUT (Input level adjustment - analog mode only)
¡
7 MIDNIGHT (Midnight mode ON/OFF - Dolby Digital mode only)
8 PANORAMA (Panorama mode ON/OFF)**
9 DIMENSION (Dimension adjustment)**
0 CENTER WIDTH (Center width adjustment)**
- CENTER FOCUS (Center focus adjustment)***
= CSII DLY (Rear speaker delay adjustment)***
~ CSII GAIN (Input gain adjustment)***
! TruBass (Trubass adjustment)***
* The adjustment is only temporary for the current input selection.
The value will return automatically to the original setup value
when the power is turned on/off or when the input selection is
changed.
** Pro Logic II Music mode only.
*** CS II mode only.
2 Use the MULTI CONTROL knob or Joystick (5/∞) to adjust the
setting as desired.
• The adjustment item is displayed for approximately 8 seconds.
•VR6050/28-34/EN 4/9/02, 4:56 PM 30