Kathrein UFS 705si - Manual (Page 10)

10
CONNECTION AND SET-UP
Connect the satellite receiver (TV Scart socket) and the TV set using a Scart cable (see “Connection
Example”). If your TV has a stereo feature, you can receive the sound in stereo via the Scart connection.
Use a further Scart cable to connect the satellite receiver (VCR/Scart socket) to the video recorder/PVR.
For system reasons, the same video signals are to be found at the TV Scart socket as at the video cinch
output.
If you want to play the sound on your hi-fi system, connect the audio cinch sockets to the input sockets on
the hi-fi system, using an appropriate cable (see “Connection Example”).
The electrical digital output is intended for the connection of a Dolby Digital system (see “Connection
Example”).
Remove the cover on the rear of the remote control.
Insert the two supplied batteries into the remote control. Ensure correct polarity of the batteries;
the + and - markings are indicated inside the battery compartment.
Slide the cover back into the housing until it locks in place.
TV AND VIDEO RECORDER CONNECTION
AUDIO CONNECTION
ELECTRICAL DIGITAL OUTPUT
INSERTING BATTERIES INTO THE REMOTE CONTROL
If you are recording using an external video recorder, remember not to operate the
receiver during recording, otherwise all the on-screen displays will appear on your
recording.