Kathrein UFS 705si - Manual (Page 59)

59
Satellite
Select the satellite to be scanned, using the

buttons. Make sure your reception system is aligned
to the selected satellite. You can scan only one satellite at a time. If you have connected a multi-feed
reception system (e.g. reception of ASTRA 19.2° East and HOTBIRD 13° East), you must repeat this
procedure once for each satellite. You can however start the fi rst installation again, in the course of
which a channel search of all the satellites you selected is performed.
Press the

button to move to the next selection item.
Channel Search Mode
Use the

buttons to select whether you wish to scan “only free and scrambled”, “only free” or
“only scrambled” channels.
To view scrambled channels you need the appropriate CA (Conditional Access) module and a valid
smart card together with a valid subscription to the respective Pay-TV provider.
Press the

button to move to the next selection item.
Network Search
Use the

buttons (On/Off) to select whether a network search should be performed. If you set the
network search to “Off”, only the factory stored transponders of the satellites you previously selected will be
scanned for new as yet unlisted channels.
If you set the network search to “On”, the transponder network enables additional transponders that
have not yet been stored to be located. They are then stored and scanned for new channels in the same
way as the existing transponders.
When you have made your settings, use the

buttons to select “Start Search” and press the
button to start the search. You can cancel the search at any time by pressing the

button. During
the search you will see the following message (example):
TV channels found
Radio
channels found
Progression bar
Satellite with the
transponder
currently being
scanned
SEARCH CHANNELS (CHANNEL SEARCH)