Kenwood KRF-X7775D - Manual (Page 97)

3
Chapter One : Connecting Your Devices
Connections
Noting Your Devices
Use this table and the diagram on the preceding page to
plan your connections before you make them, or use it to
record your connections as you make them.
If you will be connecting a DVD player or other compo-
nent with a digital output, please refer to the following chart
before choosing a video jack set:
Jack Set Device Manufacturer Model # Setup Code
PHONO
CD1
MD/TAPE1
CD2/TAPE2 MONITOR
CD-R
VIDEO1
VIDEO2
VIDEO3
DVD
MONITOR OUT
(TV on Remote Control unit)
coaxial DVD, VIDEO2 or 3
optical DVD
If your digital
cable is... Choose this jack
set...
You will need this information later, when you set up your
Remote control unit (see “Identifying Components For re-
mote control unit Control” on page␣ 40). Recording this in-
formation now will save you additional trips behind your
home entertainment cabinet. You will fill in the Setup Code
column when you are setting up Remote control unit.
When playing Dolby Digital * or DTS-encoded software in
multichannel configuration, the connected audio signal
should be the digital signal.
* When playing a LaserDisc recorded in the Dolby Digital for-
mat, connect the AC-3 RF output to the receiver (See page 26).