Kodak RP 50 2J0686 - Manual (Page 133)

Specifications
October 2002 B-11
Processor Humidity Specifications
If the humidity is low (approximately 15 - 20%), check the chemistry levels in the
tank every 2 hours. Make sure that the chemistry in each processor tank is at the
top of the overflow pipe. If necessary, add water to reach the correct level.
IMPORTANT: Operate the processor’s main drive for approximately 15 to 30
minutes after topping off the tanks.
Wash Chemicals
Telephone line
A telephone line (with a RJ11C modular phone jack) must be installed within
3 m (10 ft.) of the printer to support the remote diagnostics. We recommend a
high-grade analog service line.
Densitometer
An X-RITE DTP—36 Densitometer is required to calibrate the printer and for
process control. It is available through Kodak. See “Accessories” on page A-1.
Maximum Environmental Temperature Wash Chemical
27
o
Celsius (80
o
Fahrenheit)
Stabilizer Wash
27 o — 30 o Celsius (80 o — 86 o Fahrenheit)
Water Wash
overflow
pipe