Preventing algae (for wash configuration) – Kodak RP 50 2J0686 User Manual
Page 82
Maintaining the Equipment
4-8
October 2002
Preventing Algae (for Wash Configuration)
Add hot water to the top rollers in the wash area of the processor to prevent algae
from forming and causing chemical and transport problems.
CAUTION: Install a splash guard over the entrance area of the processor to
prevent water and chemicals from entering the printer.
Cleaning the Crossover Assemblies and Transport Racks
WARNING:
Always use two people to lift the transport rack (one person at
each end.)
Remove the crossover assemblies and the transport racks and wash them in
warm water. Be sure to wash the socks thoroughly using a soft bristle brush.
CAUTION: To prevent installing the transport racks in the wrong tank,
remove, wash, and replace each transport rack, one at a time.
splash guard
top rollers
crossover
assembly
transport rack
sock