Knoll Systems HD225 - Manual (Page 21)

21
Settings menu
Audio: allows adjustments to the volume and mute, and turns the
projector’s startup Chime on and off.
Sources: allows you to assign a particular input to a specific source
key on the remote. Also allows selection of a default Startup Source
and enables or disables Autosource and RGB Video.
Sources>Startup Source: this determines
which source the projector checks for first
for active video during power-up.
Sources>Autosource: When Autosource
is not checked, the projector defaults to the
source selected in Startup Source. If no
source is found, a blank screen displays.
When Autosource is checked, Startup
Source determines which source the
projector defaults to at power-up. If no
signal is present, the projector checks the
sources in order until a source is found or
until power-down.
Sources>RGB Video: check this box if you are using a DVD player with RGB output.
System>Rear: reverses the image so you can project from behind a translucent screen.
Ceiling: turns the image upside down for ceiling-mounted projection.
Auto Ceiling: automatically senses when the projector is inverted and turns the image upside
down. This is “On” by default.
Auto Power: When Auto Power is
checked, the projector
automatically goes into the startup
state after the projector is powered
on. This allows control of ceiling
mounted projectors with a wall
power switch.
Display Messages: displays
status messages (such as
“Searching” or “Mute”) in the
lower-left corner of the screen.
Power Save: automatically turns
the lamp off after no signals are detected for five minutes. After three additional minutes with no
signal, the projector powers down. If an active signal is received before the projector powers
down, the image will be displayed.
Screen Trigger: turns on the 12-volt DC output switch on the connector panel.
Backlight: allows you to turn off the backlighting on the keypad.