Konica Minolta Q-M100 - Manual (Page 97)

Others/Connecting camera with personal computer
● For the working environment of a personal computer, refer to the installa-
tion manual.
● Install the required software in your personal computer. Before starting
operation with the installed software, be sure to read the instructions
“Readme” supplied with the software.
● Confirm that the lens barrier is closed, a recorded CF card is set in the
camera and the camera is turned on with power supplied from batteries
or an AC adaptor.
● To save the battery power, it is recommended to use an optional AC
adaptor as a power source for the camera.
● Turn off the personal computer without fail.
1. Open the camera's I/O terminal cover and connect the camera and a
personal computer with each other by means of the connecting cord.
* Plug the 8-pin connector of the connecting cord into the camera's serial
port jack. To disconnect the connecting cord from the camera’s serial
port, refer to the instruction manual for Q-M100.
ⓐ To serial port of personal computer.
ⓑ Since the type of personal computer’s connector differs from personal
computer to personal computer, carefully read the installation manual and
use a proper connector or adaptor for connecting the cord.
ⓒ Personal computer (optional)