Kenwood DDX7017 - Manual (Page 11)

English | 11
Removing Monitor Unit
■ Removing the Hard Rubber Frame (escutcheon)
1. Engage the catch pins on the removal tool 4
and remove the two locks on the lower level.
Lower the frame and pull it forward as shown
in the figure.
2. When the lower level is removed, remove the
upper two locations.
■ Removing the Unit
1. Remove the hard rubber frame by referring
to the removal procedure in the section
<Removing the Hard Rubber Frame>.
2. Remove the Hex-head screw with integral
washer (M4 × 8) on the back panel.
3. Insert the two removal tools 4 deeply into
the slots on each side, as shown.
4. Lower the removal tool toward the bottom,
and pull out the unit halfway while pressing
towards the inside.
5. Pull the unit all the way out with your hands,
being careful not to drop it.
Be careful to avoid injury from the catch pins on
the removal tool.
The frame can be removed from the top side in
the same manner.
Removal Tool (Accessory 4)
Lock
Catch
Removal Tool
(Accessory
4)