Krown Manufacturing KBS300RX - Manual (Page 13)

MOUNTING THE KA300RX ON THE WALL
The adapter of the KA300 is supplied with a nine feet line cord for installation to a
normal outlet box.
KBS300RX BED SHAKER RECEIVER:
The bed shaker KBS300RX is a receiver. It needs to be programmed like the KA300RX
before you can actually use it in the system. To program the operation code, follow
these steps:
1. Use a small screwdriver or a penny to open the top cover. (See Chapter 2)
2. Install a rechargeable 9V battery.
3. Plug in the bedshaker and the adapter cords.
4. Feed the cord through the open gaps.
5. Close the cover and plug adapter to an electric outlet.
6. Insert one end of a paper clip into the small program hole of the KBS300RX
located on the side.
7. Press the test button on KA300TX and hold for two seconds.
8. Watch the channel LEDs. If one LED turns out stable then release the test button
on the transmitter.
9. Press test button on the TX again to make sure the bed-shaker is
working properly.
The bed shaker receiver has three memories available. If the memory is full and you
want to program a new code, you can erase the memory by unplugging the adapter and
the battery for one minute.
3: SETUP OPERATION MODE (CONT.)
9
KA300TX
OUTLET
ADAPTER