Krown Manufacturing KBS300RX - Manual (Page 16)

TESTING
It is important to perform a test for your alarm system at least once a month to make
sure the system is operating properly. You are responsible for your family safety from
fires, and any other possible disasters. Repair or replace your Alarm Monitor, and all
other alarm systems when they no longer function.
To test the KA300 system
1. Place the cover over the strobe bulb to protect your vision from the strong light.
2. Turn KA300RX power switch to the last position where it will activates both
siren and strobe light. You need to test all alarm outputs to make sure it works
when needed. Cover the strobe light before going to the next step.
3.. Press and hold the test button on KA300TX for more than three seconds or use
test button on the existing alarm device to activate the alarm system.
4. Check the KA300RX to make sure it shows the correct channel. Release the test
button on the transmitter.
Repeat the same process to test the KBS300RX. Press the reset button on the
KBS300RX to turn off the shaker.
Replace the old battery when you see the orange LED flashing rapidly on the
KA300RX. Follow this procedure when installing a new battery for your KA300RX to
protect the operation code from being erased.
1. Do not unplug the AC adapter. Take the KA300RX out from the wall.
2. Locate the battery compartment door in the back of the unit.
3. Press your thumb down firmly and slide the door toward the arrow direction.
4. Take the old battery out of the compartment.
5. Install the new battery and replace the battery door.
If the memory of KA300RX is erased by accident, you must follow Chapter 3 to
program the operation code for your receiver. Do not program the other KA300RX if it
has not lost memory.
Press the test button on the KA300TX to test the unit. If the red LED does not stay lit,
you need to replace the battery.
CHAPTER
4
TEST & TROUBLESHOOTING
12