Kompernass KH 1098 - Manual (Page 7)

- 5 -
Timer-Function
By use of the button PROG a , you can programme
the coffee maker so that it starts the brewing process at
a pre-determined time (Timer function). First, always
fill the filter
q in the filter basket 1( with coffee powder
and the water tank e with water. Place the glass
jug l in the coffee maker. Ensure that the glass jug
l is empty and the water tank e is not filled beyond
the Max marking.
• Press the button PROG a twice, so that TIMER
appears in the display t . Programme in the
desired start time with the button HOUR o and
the button MIN i (see chapter "Setting the Time").
• When the desired start time has been entered in,
press the button PROG a once more. The start
time is now programmed. The display t shows
the normal time.
• To activate the timer, press twice on the button
ON/AUTO/OFF s . The green indicator lamp
AUTO SET u glows. The coffee maker will now
start the brewing process at the programmed
time.
• If you want to deactivate the timer, press the button
ON/AUTO/OFF s . The green indicator lamp
AUTO SET u extinguishes.
Cleaning
Before cleaning, ALWAYS remove the plug from the
wall power socket.
Risk of electric shock!
Before you clean the Coffee Maker you MUST
remove the plug from the power socket.
Attention!
NEVER submerge the Coffee Maker in water.
This would irreparably damage the appliance.
Risk of burns!
Always wait until the coffee maker has cooled
down before cleaning it.
• Wipe the housing with a damp cloth. For stubborn
soiling use a mild detergent on the cloth.
• Clean the glass jug l , filter q and filter basket
1( in mild sudsy water and rinse them with lots
of clean and clear water.
Note:
Clean the Filter q immediately after use. If left until
later, it will be more difficult to clean.
If coffee powder or something similar has deposited
itself in the coffee sieve of the glass jug
l , proceed
as follows:
• Upturn the glass jug l .
• Press the two outer locks h / k inwards and
hold them firmly.
• You can now slide the coffee passage lock j
inwards. The coffee passage g opens itself.
Hold it open.
• You can release the outer locks h / k .
• Allow water to flow through the opened coffee
passage g . The residues in the sieve should be
washed out with the water. Should they still not
dissolve/detach themselves, gently scrub the sieve
with a soft brush.
IB_KH1098_E26058_LB6.qxd 21.01.2009 13:31 Uhr Seite 5