Kuppersbusch USA EKWE - Manual (Page 8)

8
Users Guide - EKWE/EKWH - USA
Then set it at the required cooking level.
An “A” will flash in the display in alternation with the cooking level set.
Residual heat indicators
As long as the cooking zone is still hot an “H” will appear in the display when
the cooking zone has been switched off.
Dual-circuit cooking zones
Dual-circuit cooking zones are indicated by means of a flashing cooking zone
symbol under the plus/minus sensors.
Depending on the size of the pan on the cooking zone, the pan-on detection
will activate either the inner cooking zone circuit alone or both circuits. The
cooking zone symbol stops flashing when both circuits have been activated.
If the pan-on detection has been switched off, the smaller cooking zone
will always heat up.
Switch on the outer circuit for large pans.
– Touch the cooking zone symbol under the plus/minus sensors.
The cooking zone symbol will stop flashing on activation.
Touching the cooking zone symbol again will deactivate the dual-circuit zone.