Kodak INNOVATION A-61506 - Manual (Page 23)

22 A-61506 September 2006
Message: Source is in wrong state for enabling.
Description/Action: Exit and restart the Brightness and Contrast
Control application. If the error occurs again, open the Scan Validation
Tool to verify that it is working properly. If it is, call Kodak Service for
assistance with the Brightness and Contrast Control. If the Scan
Validation Tool is not working properly, contact Kodak Service for
assistance with the scanner.
Message: Source failed to enable.
Description/Action: Exit and restart the Brightness and Contrast
Control application. If the error occurs again, open the Scan Validation
Tool to verify that it is working properly. If it is, call Kodak Service for
assistance with the Brightness and Contrast Control. If the Scan
Validation Tool is not working properly, contact Kodak Service for
assistance with the scanner.
Message: Unsupported scanner.
Description/Action: The Brightness and Contrast Control can only be
used with Kodak scanners. Be sure the TWAIN Source you selected is
for a Kodak scanner.
Message: Unsupported or non-existent scanner.
Description/Action: The Brightness and Contrast Control can only be
used with Kodak scanners. Be sure the TWAIN Source you selected is
for a Kodak scanner.
Message: Cannot open specified Color Table file.
Description/Action: There may be a problem with the specified color
table. If the table selected is a default Kodak color table, reinstall the
Scan Validation Tool. If this is a custom color table, you may need to
recreate the color table unless you are able to restore from a backup
copy.
Message: The specified color table file is not writable.
Description/Action: The Brightness and Contrast Control was unable
to open the specified color table file for output. This error may occur if
the color table is an original distribution color table (e.g., photo.ekct)
and the Brightness and Contrast Control will not overwrite it. It could
also mean that there is a bad file name, the file is write-protected or the
disc is full.
Message: The specified color table format is unsupported.
Description/Action: Color tables must have the .ekct extension. Only
tables provided by Kodak or created with the Brightness and Contrast
Control are supported.
Message: Incorrect checksum detected in Color Table file.
Description/Action: Color tables must have the .ekct extension. Only
tables provided by Kodak or created with the Brightness and Contrast
Control are supported.