Picture frame/computer communications, Resetting the clock after, Resetting the clock after losing power – Kodak EASYSHARE W1020 User Manual
Page 64
58
www.kodak.com/go/support
Troubleshooting and support
Resetting the clock after losing power
If you turn off the power on the frame or otherwise lose power for half a day or more,
the clock time returns to the factory setting and the automatic on/off times, if set, are
disabled.
■
When you turn the frame back on, the set time screen appears on the frame.
■
Slide to set the hour. Tap the left/right arrows to highlight the previous or next
setting (hour and minutes), then slide to adjust the setting.
■
Tap OK.
The Home screen appears. The time is reset and the automatic on/off times (if set) are
re-enabled. It is not necessary to reset the on/off times.
NOTE: If you exit the set time screen without setting the time, you can manually reset the clock and
re-enable the automatic on/off times (see
). It is not necessary to reset the on/off times.
Picture frame/computer communications
If...
Try one or more of the following
Cannot copy pictures to my
computer.
■
Make sure your frame and computer are on.
■
Make sure to install the software that was packaged with
your frame (see
) and copy pictures between your
frame and computer using the EASYSHARE Digital Display
Software (
■
Make sure the USB cable is securely connected (
■
Make sure the power button on the frame is On (
).
Cannot see my frame as a
removable drive.
Cannot copy pictures from
KODAK EASYSHARE
Software.
■
Make sure your frame and computer are on.
■
Make sure the USB cable is securely connected (
■
Make sure to install the software that was packaged with
your frame (
■
From My Collection in EASYSHARE Software, make sure the
pictures are in the Picture Tray.