Help – Kenwood DDX7034BT User Manual

Page 93

Advertising
background image

English 93

Help?

Troubleshooting

Some functions of this unit may be disabled by

some settings made on this unit.

!

• Cannot set up the subwoofer.

• Cannot set up subwoofer phase.

• No output from the subwoofer.

• Cannot set up the low pass filter.

• Cannot set up the high pass filter.

▲

Subwoofer is not set to On.

☞

<Speaker Setup>

(page 76)

▲

The DSP Select is Bypass.

☞

<DSP Bypass

Control> (page 76)

▲

The Dual zone function is enabled.

☞

<Zone

Control> (page 61)

▲

The unit is set to STANDBY source.

!

• Cannot select the output destination of the

subsource in the Dual zone.

• Cannot adjust the volume of the rear

speakers.

▲

The Dual zone function is disabled.

☞

<Zone

Control> (page 61)

!

Cannot play audio files.

▲

"CD Read" of <Disc Setup> (page 80) is set to

"2".

!

Cannot Folder select.

▲

The Random play function is enabled.

!

Cannot perform Repeat play.

▲

The PBC function is enabled.

!

• Cannot set up the equalizer.

• Cannot set up the crossover network.

▲

The Dual zone function is enabled.

☞

<Zone

Control> (page 61)

▲

The DSP Select is Bypass.

☞

<DSP Bypass

Control> (page 76)

▲

The equalizer is set to "iPod".

☞

<Equalizer

Control> (page 60)

▲

The unit is set to STANDBY source.

What might seem to be a malfunction in your unit

may just be the result of slight misoperation or

miswiring. Before calling service, first check the

following table for possible problems.

General

?

The Touch Sensor Tone doesn’t sound.

✔

The preout jack is being used.

☞

The Touch Sensor Tone can’t be output from

the preout jack.

Tuner source

?

Radio reception is poor.

✔

The car antenna is not extended.

☞

Pull the antenna out all the way.

✔

The antenna control wire is not connected.

☞

Connect the wire correctly, referring to the

section on <INSTALLATION MANUAL>.

Disc source

?

The specified disc does not play, but another

one plays instead.

✔

The specified CD is quite dirty.

☞

Clean the CD.

✔

The disc is severely scratched.

☞

Try another disc instead.

Audio file source

?

The sound skips when an Audio file is being

played.

✔

The media is scratched or dirty.

☞

Clean the media, referring to the CD
cleaning of the section on <Handling discs>
(page 6).

✔

The recording condition is bad.

☞

Record the media again or use another

media.

Advertising