KVH Industries TracVision G4 User Manual
Technical manual, Kvh tracv ision
Advertising
Table of contents
Document Outline
- Welcome Page
- Table of Contents
- 1 - Introduction
- 2 - Installation
- 2.1 - Planning the Installation
- 2.2 - Mounting the TracVision Antenna
- 2.3 - Mounting the GyroTrac Sensor
- 2.4 - Mounting the ADCU
- 2.5 - Connecting the IRD(s)
- 2.6 - Wiring the ADCU
- 2.7 - Calibrating the Sensor
- 2.8 - Activating/Programming the IRD
- 2.9 - Installing Satellites Using the ADCU
- 2.10 - Setting the Skew Angle (European Systems Only)
- 2.11 - Checking Out the System
- 2.12 - Changing Geographic Location
- 3 - Using the ADCU Interface
- 4 - Troubleshooting
- 5 - Maintenance
- 5.1 - Warranty/Service Information
- 5.2 - Preventive Maintenance
- 5.3 - TracVision G4 Field Replaceable Units
- 5.4 - Replacing the Main PCB and Fuses
- 5.5 - Replacing the RF PCB
- 5.6 - Replacing the Antenna Gyro Assembly
- 5.7 - Replacing the Elevation Motor and Belt
- 5.8 - Replacing the LNB
- 5.9 - GyroTrac Field Replaceable Units
- 5.10 - Preparing for Shipment
- Appendices
- Appendix A - System Specifications
- Appendix B - TracVision G4 Baseplate Mounting Holes Template
- Appendix C - ADCU Flush Mount Panel Template
- Appendix D - Comprehensive TracVision G4 System Wiring Diagram
- Appendix E - Optional Rotating Card Display
- Appendix F - Startup Data Sequences
- Appendix G - GyroTrac Data Outputs
- Appendix H - Maintenance Port Parser Commands
- Warranty Page