KORG C-320 - Manual (Page 37)

Assembling the stand 35
NB: You will need a cross-point (Phillips #2) screwdriver for assembly.
2 Screw the adjuster into the pedal box as far as it will go, and attach the pedal
cable.Use screws (a) to fasten the side panels to the pedal box. Make sure that there
is no gap between the side panels and the pedal box.
Assembly Accessories
Screws (b)
(M4 x 14)...6pcs.
Piano Fasteners
...2 pcs.
Adjuster...1pc.
Screws (a)
(M6 x 20)...4pes.
Cable holder
...2 pcs.
Caps...4pcs.
This is used to adjust the height
after you’ve finished assembling
the stand; don’t tighten it completely.
Screws (a)
Pull out the
pedal cable
Align precisely, so that there is
no gap between the side panel
and pedal box.