Keys Fitness KF-3.5T - Manual (Page 8)

8
Assembly
6. Connect the console harness together.
One side of harness is coming from the
right upright. The other end is coming
from the console.
Attach the console onto the uprights by
sliding into the uprights.
Secure the console to the uprights using
two bolts M10x25 and two washers #10
per side.
Figure 6: Securing Console Assembly to Uprights
Bolt M10x25
Washer #10
Console
Amplifier
Harness
NOTE: Make sure that the console har-
ness and amplifier harness are inside of
the upright and not being pinched.
Console
Harness
IMPORTANT PLEASE NOTE:
Tighten all hardware installed in Step 2
through Step 6.
EKG
Harness
Toggle
Harness
EKG
Harness
Toggle
Harness
Amplifying
Wire
Console
Harness
Figure 5: Console Assembly
Bolt M8x52
Washer #8
4. Feed the wires coming out of right side
of the console through the hole located on
the tube of the right handlebar. Connect
the amplifier wire coming from the handle-
bar to the amplifier wire coming from the
console. Connect the EKG harness and the
toggle harness coming from the handlebar
to the EKG harness and the toggle harness
coming from the console. Secure the right
handlebar to console using two bolts M8x52
and two washers #8.
Feed the wires coming out of the left side
of the console through the hole located on
the tube of the left handlebar. Connect the
EKG harness and the toggle harness com-
ing from the handlebar to the EKG harness
and the toggle harness coming from the
console. Secure the left handlebar to con-
sole using two bolts M8x52 and two wash-
ers #8.
NOTE: Make sure not to pinch or screw
through any wires when securing the left
handlebar.