Preparation, Installing alkaline batteries – Kenwood VC-H1 User Manual
Page 7
3
PREPARATION
INSTALLING ALKALINE BATTERIES
WARNING!
◆
DO NOT INSTALL THE BATTERIES IN A HAZARDOUS
ENVIRONMENT WHERE SPARKS COULD CAUSE AN
EXPLOSION.
◆
NEVER DISCARD OLD BATTERIES IN FIRE BECAUSE
EXTREMELY HIGH TEMPERATURES CAN CAUSE BATTERIES
TO EXPLODE.
1 To remove the battery cover, slide the cover outward
while slightly pushing on the grooves on the cover.
2 Insert four AA (LR6) alkaline batteries.
•
Be sure to match the battery polarities with those
marked on the VC-H1.
3 Align the three tabs on the battery cover, then slide
the cover inward until the center tab clicks.
Note:
◆
It is strongly recommended to use high quality alkaline batteries
rather than manganese batteries, to enjoy longer periods of battery
life. Do not use commercially available NiCd batteries.
◆
If you will not use the VC-H1 for a long period, remove the batteries
from the VC-H1.
◆
Do not use different kinds of batteries together.
◆
When the battery voltage is low, replace all four old batteries with
new ones.
The approximate lives of alkaline batteries depending on
the operation status are shown below:
When the batteries become almost empty while the
TX/RX indicator is green, the indicator starts blinking.
Replace the batteries at that time. This function,
however, does not operate while Fast FM mode is
currently selected.
Grooves
Center tab
N
O
a
r
e
m
a
C
s
e
t
u
n
i
m
0
5
)
d
e
ll
a
c
e
r
y
r
o
m
e
m
(
N
O
r
o
t
i
n
o
M
s
r
u
o
h
2
F
F
O
r
o
t
i
n
o
M
s
r
u
o
h
6