Kompernass POF1300 - Manual (Page 11)

13 GB/IE/CY
Preparing for use / Operation
Q Attaching the vacuum extraction
adapter (with reducer piece)
m Warning: Always pull the mains plug is out
of the socket before doing any work on the device.
This precaution is intended to prevent you from
unintentionally starting the device.
Note: Remove the router bit before you attach the
vacuum extraction adapter
31 .
j Place the vacuum extraction adapter 31 on to
the base plate 5 . Fasten the vacuum extraction
adapter 31 to the base plate 5 using the two
screws 30 . Screw the two screws 30 in from
below.
If it is necessary to use the reducer piece 32 , it
can be pushed into the vacuum extraction
adapter
31 .
j Connect a vacuum extraction device suitable
for extracting dust and chips by means of a
suction hose to the vacuum extraction adapter
31 or to the reducer piece 32 .
Q Operation
Connect the device by its mains plug to a power
source supplying 220 V - 230 V ~ 50 Hz.
Q
Switching on / off
Switching on
j To switch off the device first press the safety
lock-out 24 and keep it depressed. Then press
the ON / OFF switch 23 .
Switching off
j To switch off the device, release the ON / OFF
switch 23 again.
Illuminating the routing area
j The integrated illumination for the routing area
lights up and can be switched off again by
pressing the On / Off switch
23 .
Q Preselecting the
rotation speed
j Set the required rotational speed using the
thumbwheel for speed preselection 25 .
1-2 = low rotational speed
3-4 = medium rotational speed
5-6 = high rotational speed
j If possible always determine the optimum setting
beforehand using a practical test.
j If you have been working for a long period using
a low rotational speed, you should cool the
device by running it at the highest speed for
about 1 minute under no-load conditions.
Q Table of indicative rotational
speeds (for guidance only)
Material Router
bit Speed
setting
Aluminium 4-15 mm
16-40 mm 1-2
1
Plastic 4-15 mm
16-40 mm 2-3
1-2
Chipboard 4-10 mm
12-20 mm
22-40 mm 3-6
2-4
1-3
Softwood
e.g.: spruce,
pine, fir 4-10 mm
12-20 mm
22-40 mm 5-6
3-6
1-3
Hardwood
e.g.: maple,
birch, oak,
cherry 4-10 mm
12-20 mm
22-40 mm 5-6
3-4
1-2
The indicative values in the table are for guidance
only. The required rotational speed depends on the
material and the working conditions and should be
determined by means of a practical test.