Kompernass POF1300 - Manual (Page 13)

15 GB/IE/CY
Operation
j Tighten the stop screw 9 for depth stop 10
again.
j Release the clamping lever 15 by turning it
clockwise and then guide the device back up
again. Check the depth of cut by carrying out
a further practical test.
Setting the depth of cut using the step
buffer
You can use the step buffer
7 to make greater
depths of cut in several successive stages in which
less material is removed.
j Set the required depth of cut with the lowest
step of the step buffer 7 (as described
above).
j Afterwards the higher steps can be used for
the first few cuts.
Q Direction of feed
m Danger! When machining with the direction
of rotation the router can be ripped out of your
hands. This may cause injury.
J Always machine against the direction of
rotation of the router bit!
Q
Routing process
j Adjust the depth of cut as described above.
j Place the device on the workpiece and switch
it on.
j Release the clamping lever 15 by turning it
clockwise and press the device downwards un-
til the depth stop
10 runs against the workpiece.
j Lock the device by turning the clamping lever
15 anticlockwise.
j Carry out the routing process using uniform
speed and pressure
j Stop the routing process by lifting the device
from the workpiece and switching it off.
Q Setting the guide bushing
j Insert the guide bushing 35 from below into the
guide plate 6 .
j Fasten the guide bushing 35 to the base plate
5 using the two screws 30 of the vacuum ex-
traction adapter. Make sure that the guide
bushing
35 is the right way round - the guide
bushing ring 36 must be facing downwards.
Q Routing with the guide bushing
Note! When using the guide bushing, the template
must have a minimum thickness of 8 mm.
Note! The template must be at least as thick as
the guide bushing ring
36 of guide bushing 35 .
Note! Choose a router bit with a smaller diameter
than the internal diameter of the guide bushing.
By using the guide bushing 35 you can superimpose
templates or patterns on to the workpiece.
j Place the device with the guide bushing
against the template.
j Release the clamping lever 15 by turning it
clockwise and lower the device until the previ-
ously set depth of cut is reached.
j Now guide the device with the projecting
guide bushing along the template, whilst apply-
ing light pressure.
Q
Routing with the guide fence
j Insert the guide fence 27 into the guide rails 22
of the base plate 5 and fasten it into place to
suit the required dimension using the locking
screw
21 .