Konica Minolta NON-CONTACT 3D DIGITIZER VIVID 9i - Manual (Page 2)

Safety Symbols
The following symbols are used in this manual to prevent accidents which may occur as result of incorrect use
of the instrument.
Notes on this Manual
• Copying or reproduction of all or any part of the contents of this manual without KONICA MINOLTA
SENSING’s permission is strictly prohibited.
• The contents of this manual are subject to change without prior notice.
• Every effort has been made in the preparation of this manual to ensure the accuracy of its contents. However,
should you have any questions or find any errors, please contact a KONICA MINOLTA SENSING-author-
ized service facility.
• KONICA MINOLTA SENSING will not accept any responsibility for consequences arising from the use of
the instrument.
• Company names and product names which appear in this manual are their trademarks or registered trade-
marks.
• Contents and display examples given in this manual are subject to change.
About This Manual and Related Documents
The VIVID 9i Non-Contact 3D Digitizer offers rapid, high-precision 3D scanning ideal for imaging of indus-
trial products in a wide range of shapes and configurations. This manual describes the digitizer’s features and
operating procedures, and calls attention to relevant precautions.
Please also refer to documents listed below for related information.
Denotes a sentence regarding safety warning or note.
Read the sentence carefully to ensure safe and correct use.
Denotes a prohibited operation.
The operation must never been performed.
Denotes an instruction.
The instruction must be strictly adhered to.
Denotes an instruction.
Disconnect the AC power cord from the AC outlet.
Denotes a prohibited operation.
The part must never be disassembled.
Denotes an instruction.
Connect the grounding terminal as instructed.
Denotes a sentence regarding safety precaution for laser.
Read the sentence carefully to ensure safe and correct use.
Document Content
Polygon Editing Tool
Instruction Manual Explains how to install and use the Polygon Editing software, and gives details
about all of the software’s features. The Polygon Editing Tool software can be
used to control the operation of VIVID non-contact 3D digitizers, to convert
scanned data into polygon data, to edit and process the scanned data, and to save
the data into standard formats.
Polygon Editing Tool
Basic Operations Guide Explains the basic operations of the Polygon Editing Tool software, with refer-
ence to the VIVID 910 digitizer.
Photogrammetry System
PSC-1 Instruction Manual Explains the PSC-1 system, a high-precision alignment system based on photo-
graphic measurement technology. This system is for use in the VIVID 9i only.
Vivid910-hard-E.book Page 2 Monday, October 18, 2004 3:11 PM