Kenwood KRF-V4080D - Manual (Page 23)

23 EN
ENGLISH
Presetting radio stations manually
The RDS auto memory function assigns preset numbers to RDS stations
starting from preset number “1”. Therefore, be sure to execute the RDS
auto memory function before using the following operations to manually
store AM stations and other FM stations, and RDS stations.
See “Presetting RDS stations (RDS AUTO MEMORY)”.
¢
MULTI CONTROL
MEMORY
1
Tune to the station you want to store.
2
Press the MEMORY key while receiving the station.
3
Use the MULTI CONTROL knob to select one of the station
presets (1 – 40).
4
Press the MEMORY key again to confirm the setting.
• Repeat steps 1, 2, 3, and 4 to store as many stations as
necessary.
• If you store a station at a previously used preset, the previous station
will be replaced by the new one.
Receiving preset stations
TUNER
Numeric keys
1
Press the TUNER key to select tuner as the source.
Listening to radio broadcasts
2
Enter the number of the preset station you want to receive
(up to “40”).
Press the numeric keys in the following order:
For “15”, press ................................ 0, 5
For “20”, press ................................ 0, 0, )
• If you make a mistake entering a two digit number, press the +10
key repeatedly to return to the original display and start again.
Receiving preset stations in order
(P.CALL)
TUNER
P.CALL
4 / ¢
1
Press the TUNER key to select tuner as the source.
2
Use the P.CALL 4¥¢ key to select the desired station.
• Each time you press the key, another preset station is received in
order.
Pressing the P.CALL ¢ does the following :
Pressing the P.CALL 4 does the following :
Holding down the ¢ or 4 key, lets you skip through the
presets, receiving each preset station at 0.5 second intervals.
Proceed to step 3 within 5 seconds.
(If more than 5 seconds elapse, press the MEMORY key again).
Blinks for 5 seconds Lights for 5 seconds
04.1.24, 7:13 PM 23