Kenmore 415.162090 - Manual (Page 18)

18 • 463350505
6.
An additional one-half to
three-quarters turn is required to complete the
connection. Tighten by hand only – do not use tools.
NOTE:
do not use this regulator!
Turn the coupling nut clockwise and tighten to a full stop. The
regulator will seal on the back-check feature in the LP tank
valve, resulting in some resistance.
If you cannot complete the connection, disconnect regulator and
repeat steps 5 and 6. If you are still unable to complete the
connection,
Straight
Hold coupling nut and regulator
as shown for proper connection
to LP tank valve.
DANGER
• Do not insert any tool or foreign objects into the valve outlet
or safety relief valve. You may damage the valve and cause
a leak. Leaking propane may result in explosion, fire, severe
personal injury, or death..
• If a leak is detected at any time, STOP and call the fire
department.
• If you cannot stop a gas leak, close LP tank
valve and call LP gas supplier or your fire department!
immediately
Leak Testing Valves, Hose and Regulator
1. Turn all grill control knobs to OFF.
2.
3.
Correct
before proceeding
1-800-4-MY-HOME .
4.
Be sure regulator is tightly connected to LP tank.
Completely open LP tank valve by turning OPD hand wheel
counterclockwise. If you hear a
, turn gas off
immediately. There is a major leak at the connection.
by calling Sears for replacement parts at
Brush soapy solution onto areas where bubbles are shown in
picture below:
rushing sound
®
s Never remove threaded
orifice at end of valve.
5. If “growing”
If leaks cannot
be stopped do not try to repair.
1-800-4-MY-HOME
6.
bubbles appear, there is a leak. Close LP tank
valve immediately and retighten connections.
Call Sears for replacement
parts at .
Always close LP tank valve after performing leak test by
turning hand wheel clockwise.
®
WARNING
• Never attempt to attach this grill to the self-contained LP gas
system of a camper trailer or motor home.
• Do not use grill until leak-tested.