KTM 950 - Manual (Page 73)

CLEANING
»
72
Clean your motorcycle regularly in order to maintain the beauty of its plastic surfaces.
The best manner would be to use warm water that has been mixed with a normal brand-name washing detergent and a sponge.
The hard dirt can be removed before washing with the help of a soft water jet.
If using a power washer, do not point the water jet at the electric components, plugs, cables, bearings, carburetor, etc. The high pressure
will cause water to penetrate into the components and can cause them to malfunction or lead to premature wear.
– Before you wash your motorcycle, close the muffler openings.
– Use warm water with a commercial detergent and sponge. Coarse dirt can be removed with a soft water jet. Areas that are heavily soiled
can be sprayed with a motorcycle cleaner (e.g. Motorex 900) and cleaned with a brush.
– After the motorcycle has been rinsed with a soft water jet, it should be dried by air pressure and a cloth. Then take a short drive until
the engine has reached the working temperature and also use the brakes. Due to the heat, the water also evaporates at the unapproach-
able parts of the engine and the brakes.
– Slide back the protective covers on the handlebar-mounted instruments so that any water that may have seeped into this part of the
motorcycle is allowed to evaporate.
– After the motorcycle has cooled down, oil or lubricate all of the friction bearings and bearing positions and treat the chain with chain
spray. Treat all bare areas (except brake disks) with a corrosion inhibitor (e.g. Motorex Protect & Shine).
– The exhaust pipes and mufflers are made of stainless steel and should be treated with a suitable care product.
– To prevent the electric system from malfunctioning, treat the ignition lock, emergency off switch, combination switch and connectors
with contact spray.