KORG TRITON Musical Instrument - Manual (Page 47)

TRITON Training Guide
45
Recording One -Shot Vocal Samples
Here's a quick and easy way to make a sample - all it takes is a microphone:
1. Clear the TRITON's sample RAM by powering - OFF, then ON (when you get more comfortable with
TRITON you can learn how to erase all samples without powering off). Connect a microphone to the
Input 1 jack on the rear panel, set the MIC / LINE switch to MIC, and set the LEVEL control to the 12
o'clock position.
2. Press the SAMPLING key to enter Sampling mode.
Input Setup Tab:
3. Press the Input Setup tab, then, in the Input 1 field, press the popup button, and set the BUS (IFX)
Select to L / R.
4. Set the Input 1 Pan: value to C064 with the DIAL or Numeric keys.
5. In the Recording Setup field, press the Auto radio button, set the Threshold to -30 dB, then set the
Pre Trigger REC value to 5ms with the DIAL or Numeric keys.
Recording Tab:
6. Press the Recording tab, and make sure that the MS: ( multi-sound ) is set to 000: New MS___000
(you're already there, if you powered OFF / ON before beginning this section).
7. In the REC Sample Setup field, set the Sample Mode: to L - Mono with the DIAL or Numeric keys.
8. Set the OrigKey: C2 and the TopKey: C2 - you can easily -set these values by pressing to highlight
each Orig and Top key in the display, and while holding the ENTER key, press C2 (low - C) on the
keyboard.