Hardware installation, Front panel, Power led – Kingston Technology KND2410TX User Manual
Page 10: Collision leds, 100tx (speed-detection) leds, Link / activity leds
4 Front
Panel
Kingston Technology Company KND2410TX User’s Guide - Rev. A01
Hardware Installation
Before you begin installing network cables, please take a few minutes to
familiarize yourself with the dual-speed hub. See the diagram below:
Front Panel
Fig. 1-2 KND2410TX Front Panel
Power LED
The green LED indicates the power status. The LED will light up when the AC
power connector is properly connected to a power source.
Collision LEDs
There are two (2) separate collision LEDs for both 10Mbps and 100Mbps
segments. If a collision is detected on a 10Mbps segment, the “10” LED will
flash amber. If a collision is detected on a 100Mbps segment, the “100” LED
will flash amber. Collisions occur when 2 or more ports receive data
simultaneously
100TX (Speed-Detection) LEDs
The 100TX LED lights up when 100Mbps operation is detected. The 100TX
LED will not light up if 10Mbps operation is detected.
Link / Activity LEDs
The LINK / ACTIVITY LEDs service both 10BASE-T and 100BASE-TX
operation. A steady green light indicates that a good link has been established.
A flashing green light indicates that data is being received.
If the Link LED does not display a steady green link light, please check the
following:
24
5
6
7
8
9
10
11
12
17
18
19
20
1
2
3
4
13
14
15
16
21
22
23
24
Uplink Port
Power LED
Collision LEDs
for 10 and 100
10/100BASE-TX
UTP Ports
100TX LEDs
Link / Activity LEDs