Kyocera SL300R - Manual (Page 21)

1-5
1
Camer
a Prepar
ation
s
• When the card access LED is flashing, images are being recorded onto the memory card.
Do not open the card/battery cover or remove the memory card while the LED is flashing
as this could cause data corruption or, in some cases, camera damage.
• Check that a memory card is loaded in the camera before switching the camera on.
• While the camera is switched on, pressing the POWER button H switches the camera off.
2
Push the memory card in gently
with your fingertip.
If you push the memory card in slightly, it pops
back out and you can then pull it out completely.
3
Close the card/battery cover.
Close the cover and slide it in the opposite
direction to the arrow (U) to lock it.
Switching the Camera On
Press the POWER button
H
.
The startup screen is displayed for a few seconds and
then the normal shooting mode screen appears.
M
G
Finecam_E.book Page 5 Thursday, August 28, 2003 6:21 PM