Konica Minolta Image Controller IC-205 - Manual (Page 78)

Control panel operations 6
IC-205 6-7
C
ontr
o
l pa
nel
op
er
ati
ons
Ch
apt
er
6
Using the bypass tray
Use the procedure described below to print onto paper that is fed (one sheet
at a time) from the bypass tray.
1
On your computer, display the “Setup” tab of the printer driver, and
then specify “Bypass” for the
Paper Source setting (page 5-16).
2
Execute the print operation from your computer.
3
When the message LOAD PAPER
appears on the machine’s display,
load paper onto the bypass tray.
This causes the print operation to be
performed using the paper from the
bypass tray.
4
Repeat step 3 as many times as nec-
essary until printing of the document
is complete.
2
Note
Be sure to execute the print operation from the computer first, and then
place the paper onto the bypass tray. If there is already paper on the by-
pass tray when you execute the print operation, remove it, and then place
it again onto the bypass tray.
Load the paper into the manual bypass tray one sheet at a time.
If the multi bypass tray (optional) is installed, it can used in the same way
as any other paper tray since the multi bypass tray can hold 100 sheets
of paper.
The multi bypass tray can be loaded with a maximum of 10 envelopes,
20 OHP transparencies, 20 postcards, 20 label sheets, or 100 sheets of
plain paper.