Kompernass KH 700 - Manual (Page 10)

- 8 -
• When you have finished,
switch off the blender and first
remove the lid 2 by turning it
clockwise.
• Then remove the blender jug
4 by turning it clockwise.
Hints:
• You can add your ingredients to the blender jug
4 through the opening in the lid 2 during ope-
ration. To do so, simply remove the splash protec-
tion cap 1.
• If you process hot liquids, remove the splash
protection cap 1 to allow the steam to escape.
• Should ingredients be trapped in the blender jug
4 during operation, proceed as follows:
- Switch off the device (speed controller 7 to le-
vel 0) and pull the plug from the socket.
- Remove the splash protection cap 1 and the
lid 2.
- Remove the trapped ingredients in the blender
jug 4 using the spatula o. Ensure you do not
damage the spatula o with the blade z!
9. Cleaning & Care
ƽ
Caution:
Never immerse the device in water or other
liquids. There could be potential hazard of
life-threatening electric shock, if moisture en-
ters the voltage conducting parts upon opera-
ting the appliance again.
• Exercise special care when cleaning the blades
z, the blender jug 4 with installed blade and
the cutting discs (I-VI). The blades and cutting ed-
ges are extremely sharp! Risk of injury!
• Wipe the housing with a clean, damp cloth after
each use.
ƽ
Warning regarding appliance
damage:
NONE of the appliance components are designed
for cleaning in a dishwashing machine! Additional-
ly, do not use abrasive cleansers for cleaning appli-
ance components.
• You can clean the mixing bowl 9 and the lid 0
in hot soapy water.
• Always remove the plug from the socket before
cleaning the appliance. Otherwise, you are at
risk of receiving an electric shock!
• Clean all appliance components that have come
in contact with foodstuff with detergent and hot
water after use.
• Use an appropriate dishwashing brush for places
that are difficult to access.
10. Malfunctioning
If the food processor suddenly stops functioning:
It means that the appliance has overheated and the
integrated safety cut off has switched off the food
processor.
• Pull the plug from the socket
• Set the speed controller 7 to level 0
• Allow the device to cool down for 15 minutes
• If the appliance has not cooled off completely
after 15 minutes, it will not start. Wait another
15 minutes before switching it on again.
If the food processor does not switch on:
• Check whether the power plug is inserted in the
socket.
IB_KH700_E41968_LB6 17.11.2008 14:33 Uhr Seite 8